PSX01 commands repeated

[fixer]

I need a repeater that will also repeat the commands of the KR22a and KR19a as well as other sensors and such.  I have not been able to get the PSX01 to do this.  I originally purchased an sr731 but was shipped the PSX01 instead.  Has anyone else ran into this issue or found a way around it?  I would like to use the remotes and homelink from my car as I drive up to the house.

Thanks

[KDR]

I have not had a chance to play with it yet but I ordered a SR731 and got a PSX01 also. I have not looked at any specs but isn't the 2 the same? The PSX01 is just the Pro version?

[fixer]

I have read in different places that the psx01 will not retransmit some of the pan,etc. commands for the cameras that the 731 does.  I am wondering if that applies to the slim line remotes as well...  What I have doesn't work together(PSX01, KR22a).

[Charles Sullivan]

I have read in different places that the psx01 will not retransmit some of the pan,etc. commands for the cameras that the 731 does.  I am wondering if that applies to the slim line remotes as well...  What I have doesn't work together(PSX01, KR22a).

I'm seeing something similar:  My SR731 works with some SS13A "Stick-a-Switch" units but not others.

For the "bad" SS13A units, the LEDs on the SR731 don't blink and the signal isn't repeated (as determined from a W800RF32A receiver).

All the  SS13A units work fine with a Transceiver, so I assume the SR731 is sensitive to some minor timing or frequency discrepancy between the units.

For this SR731, there's no indication from the LEDs that it's repeating any of the Pan/Tilt signals transmitted by a CR14A Pan/Tilt remote other than from the Camera Selection buttons (which are just standard X10 RF).