Topic: contact closure to trigger transmit X10 command code to an Applicance module (Read 3743 times)

froggy · « **on:** November 12, 2006, 05:24:14 PM »

I am interested in some comment on how I can best use a switch contact closure to trigger the transmision of an X10 code to activate an applicance module at another location. In effect, I need to trigger an X10 wall switch triggerd by a spst contact. Any suggestions?
The universal module works on the recreiving end of the command transmission.
I need a similar kind of a module that acts as an X10 switch with an external isolated dry contract closure.

Puck · « **Reply #1 on:** November 12, 2006, 05:28:58 PM »

The Opposite of Universal Module is the PowerFlash

Brian H · « **Reply #2 on:** November 12, 2006, 06:17:21 PM »

Powerflash will do what you want.
I have one triggered by a doorbell current sensor [it can accept a low DC or AC voltage also besides the dry contact trigger]. It sounds a chime module in the cellar where I can't always hear the doorbell.

News:

Author Topic: contact closure to trigger transmit X10 command code to an Applicance module (Read 3743 times)

froggy

contact closure to trigger transmit X10 command code to an Applicance module

Puck

Re: contact closure to trigger transmit X10 command code to an Applicance module

Brian H

Re: contact closure to trigger transmit X10 command code to an Applicance module