Topic: WTD: Wired Light Switch That Can Trigger Macros (Read 3285 times)

sam molone · « **on:** December 26, 2006, 03:55:37 PM »

Is there such a light switch that I can hard wire in and when you turn the light switch on it will send a X10 code to do a macro which then turns on a group of lights and when you switch it off it will do another macro to turn of the group of lights?

Puck · « **Reply #1 on:** December 26, 2006, 06:18:05 PM »

ICON On/Off Switch will send an X10 ON & OFF commands during manual operation. This can trigger a macro or control other switches on the same address. (There is also a dimmer version available.)

gil shultz · « **Reply #2 on:** June 13, 2007, 04:00:19 AM »

Use one of the occupancy sensors that has the dawn/dusk sensor and mount it so it sees the light but not people or just disable the motion sensor portion.

Gil Shultz

News:

Author Topic: WTD: Wired Light Switch That Can Trigger Macros (Read 3285 times)

sam molone

WTD: Wired Light Switch That Can Trigger Macros

Puck

Re: WTD: Wired Light Switch That Can Trigger Macros

gil shultz

Re: WTD: Wired Light Switch That Can Trigger Macros