Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Question about Module Status choices  (Read 3556 times)

LarryG

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Question about Module Status choices
« on: January 08, 2007, 10:58:32 PM »
In Advanced Macros, if I edit the Module Status ("If these Modules are On") the choices are limited to a single house code, that is C1 to C16. I don't want a 'C' house code but rather a 'D' house code. How do I make the Module Status show house codes D1 through D16 ?
Logged

Dan Lawrence

  • Hero Member
  • *****
  • Helpful Post Rating: 68
  • Posts: 3991
Re: Question about Module Status choices
« Reply #1 on: January 08, 2007, 11:06:27 PM »
Modules, both lamp and appliance can access all housecodes from A-P and addresses from 1-16.  They are set by the code wheels. Socket Rockets have no code wheels, but can be set to the same ranges as modules by usiing a M460 and a lamp.
Logged
I don't SELL this stuff... BUT I sure do ENJOY using it!!!

Puck

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 171
  • Posts: 1799
Re: Question about Module Status choices
« Reply #2 on: January 08, 2007, 11:17:47 PM »
Quote from: LarryG on January 08, 2007, 10:58:32 PM
How do I make the Module Status show house codes D1 through D16 ?

Under Tools / Hardware Configuration, Set your Monitored House Code to 'D'.
Logged

LarryG

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Re: Question about Module Status choices
« Reply #3 on: January 08, 2007, 11:25:05 PM »
Thanks Puck! That was the "magic answer". Much appreciated. 
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.