I have been having fun figuring this stuff out, actually got a motion detector on A1 to trigger a macro A1 to select a camera on B1, pan to a position, start recording for 30 seconds, stop recording, and go back to position 1. However, I can see that while looking at the software while the macro is running, the motion detector is continually detecting motion triggers which seems to throw the macro into a loop. Is there a way after the motion initially triggers and has activated the macro to disable that motion detector until the macro the motion detector has triggered is finished and then turn the motion detector back on again. I have been reading around and have seen that with the smart macros flags can be set, however all I have is the AHP with Iwatchout and the basic macro designer. I have tried having the first command as turning A1 module off (the address of the motion sensor) but that does not seem to work. Any ideas?
Thanks in Advance
My System
-------------------------------------
Computer: Windows XP, AMD 3200+, ATI Radeon x700 series/256mb, 1 Gig Ram
AHP Version: 3.204 with Iwitness plugin
VA11A driver version: 3/19/2001, 2.0.0.55
Lorex Color Quad Processor SGQ4160
VA11A - USB video adapter capture
CM15A - Computer interface with USB cable
Camera: Astak CM-818W night vision color CM-818W
(2) Ninja VK74A Pan and tilt system