Video recording with Vanguard

Started by jstoufer, November 16, 2007, 04:31:31 PM

Previous topic - Next topic

jstoufer

When recording video  it makes a 5 minute movie then another 5 minute movie,etc,etc.  Is there any way to change this?  Having 12 separate movies every hour is not my idea of a good way to record video!

Don N

That's about the best you can get is 5 minute videos.  There are several discussions about this on the forum.  It's my experience that the only way you can change the amount of time the video records is under Tools, Preferences, Video Settings, Frame Rate.   The lower the number the longer the video and the more "herky-jerky" the recording.  Higher number the smoother the movement, but less recording time.  I've experimented with different settings like the Disk Space Threshold under General Video as well as changing the Quality under Compression Options.  But, the best recording time I can get now is about 5- 5 1/2 minutes.   

zach1234

Same with me. Your luckey some users olny get about 14 sec.

bhoffman67

"Tools, Preferences, Video Settings, Frame Rate."

The above menu structure doesn't exist in Vanguard... I bet it does in ActiveHome Pro, but this post was in the VICC forum so I think Don might be misleading jstoufer about the how-to.

Augus

Is there a way to change default location where your video will be record too? cause my C:/ drive is full, but I have external hard drive which I can record too. Thanks,
1 Wireless PC Transceiver (CM19A);
1 PAN AND TILT KIT (CR14A)
4 EagleEye Motion Sensor (MS14A)
1 Vanguard Control Center Software (SW26A)
1 Small Wireless Transceiver (TM751)
1 VCR Commander II (UX23A)
1 USB Video Capture Apapter (VA11A)
1 Pan & Tilt Base (VK74A)
1 Small Video Receiver (VR36A)
2 XCam2 Instant-On Camera (XX16A)
2 NightWatch Wireless Low-Light B/W Video Camera (XX20A)

zach1234

Just tell it where to save and it will eventualy learn.

SMF spam blocked by CleanTalk