So, I have a number of light switches being controlled automatically by AHPro on code "L". Everything with the macros/timers was working fine; lights come on at night, go off at dawn, etc. Then, I plug in a TM751 also set to "L", so I could use a PalmPad Remote HR112A to control some of the lights in the house manually. Now, none of the automated timers/macros run any longer. I unplug the TM751, and they work fine again. So, I realize that the TM751 must be "interfering" with the commands being sent to the lights on "L" by AHPro. However, I can not figure out how I can program my remote to control those lights using a different code than "L". I thought I could write a macro for each light, using an activation code like "M", but I see no way of controlling the light switches so that the ON/OFF and DIM buttons on the remote control that light. My main house code being monitored is "A", which is what the motion sensors are using. What am I doing wrong?