Radio Shack 49-1000 "LOW BATT 3" Display

Started by JSPhotoe, November 23, 2008, 10:55:52 AM

Previous topic - Next topic

JSPhotoe

 :-[ I have the RS 49-1000 wireless alarm system. It has been working fine for 3 years. The other day I came home and it read "LOW BATT 3" . Never seen this before. It usually does this when I disarm it with the remote. I only have 2 zones on my system so I don't understand where the 3 comes in. My pin doesn't work when this happens. I disconnect the power, and remove the batteries out. I then replace the batteries, and replace the power cord. The display then reads "tamper" which is what I would expect. Then my pin will work. Then the next time I have it armed for a several hour period, and then disarm it with the remote I get the "LOW BATT 3" message again. I have never replaced the battery in the remote, but I am not sure why that would cause this to happen.

I was just wondering if anyone else has had this issue or could shed some light on this before I replace it?


Another question would be: Are the X10 systems any more reliable than the radio shack units?

Thanks

Brian H

You may want to try a set of batteries in the remote. Also have you ever changed the batteries in the wireless door and motion sensors?

JSPhotoe

#2
I have changed the batteries in both sensors, and the main unit. I have not changed them in the remote yet, and that is going to be the next thing. The batteries in the remote check out fine!

Any other suggestions?

SMF spam blocked by CleanTalk