Need X10 powerline receive and vdc in same module

Started by Brandt, February 19, 2010, 02:33:21 PM

Previous topic - Next topic

Brian H

#15
A few points.

As a camera supply it is normally in a group of four Unit Codes 1-4;5-8;9-12 and 13-16 and the same House Code.
So if you are using C1 for the supply. An On to C2;C3 or C4 will automatically turn off the C1 supplies switched voltage.

Also the output of the supplies are not regulated. If my memory is correct. A Ninja XM14A lightly loaded was almost 17 volts.

Only one of the supplies you mentioned that I know about has more current capacity for the Ninja Mount the XM14A.
Some of the cameras didn't have instant on where part of the camera is live all the time and the RF is turned on and off. The older 3 second for picture ones maybe some of the supplies you mentioned. They also had a different connector for the camera power.

Specfications of many X10 units here includuing the XM series supplies.
http://kbase.x10.com/wiki/Category:Specifications

dbemowsk

Here is a simple 5 volt regulator schematic that can be easily wired up on a small piece of pre-drilled PC board from rat shack and point to point wired to give you the  regulated 5 volts needed.  It can be built with 4 components (a 5 volt regulator,2 capacitors and a diode).  If you don't feel like soldering this together, you can just wire in something like Dave_x10_L suggested in his previous post with the USB car adapter thing.

Dan B.
Dan Bemowski
Owner of PHP Web Scripting LLC
Programmer of RemoteWatch X10
User of any X10 products I can get my hands on.