AHP shows low battery on sensor?

Started by birdzeye, December 09, 2010, 04:07:18 PM

Previous topic - Next topic

birdzeye

AHP is indicating a low battery on one of my door/window sensors. So I put fresh batteries in the sensor and now the zone indicator light is ON for that sensor on my security console. WTF? Am I going to have to reset the entire system now? Arghhhhhhhhhhhhh...!!

JMac

I think you leave the batteries out for 4 hours and then reinstall and it will go in the right position and security code, but I'm not sure.  You need to search for this here on the forum.

tom j

Here's what to do after a few hours if it doesn't correct itself just set the console to install and push the reset button on the sensor and the flashing will stop and it will once again be registered in that position.

Tom j.

SMF spam blocked by CleanTalk