RF repeater with pan tilt.

[tybirdtybird]

Would RF  repeater work with it ?

[dave w]

Would RF  repeater work with it ?

It should. The Ninja P&T movement is controlled by RF from the remote or the computer, but X10 hasn't made the RF repeater in years. Many problems with it.

[Brian H]

The X10 repeater has been discontinued for awhile.
We have also seen reports of probelms when the repeater was in a system.
You may want to do a search here and see if you can find posts on it.

[tybirdtybird]

Thanks Guys

I think i should have said RF extender. I need little more range with it. Like radio shack sell them to extend the range of TV remote. I have to aim the remote at one spot of my bedroom for to work.

I take care of my mom and dad so use the camera to keep an eye on them the both fall a lot.
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                 

[dave w]

I think i should have said RF extender. I need little more range with it. Like radio shack sell them to extend the range of TV remote.

That is surely an IR extender, not a RF extender, isn't it? IR extender won't help you.

The Ninja movement signal is 310MHz from the hand held remote or the CM15A, CM19A etc. If you are using a fixed transmitter like the CM15A or the CM19A you might try moving them around to find a "sweet spot". Higher the better.

[Brian H]

As dave w pointed out. The pan and tilt is a direct RF command. That has to reach the base directly from the remote;CM15A or CM19A for control.