Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[bri-ko]

I'm trying to install the DS7000 security pkg and bought the option for my active home to interface with he security sys.  I've currently installed three door sensors two of which register properly with active home but the third does not.  I'm thinking that the sensor may be too far from the active home interface and is not being detected.  My question is:  Can I use a transceiver to make this work.  I've tried on set to house code A but didn't seem to help.

TIA

[Knightrider]

No.  The security sensors send a different type signal than the others (eagle eyes, hawkeyes, hand held remotes, etc.)

[bri-ko]

Knightrider and all,

Thanks for reading/responding!  It seems I was right with the distance problem.   I just added a short piece of wire to the antenna connection on the DS12A and now it is recognized by Active Home.  it seems to be reliable now.

 

[Knightrider]

I love it when a plan comes together.

[Brian H]

The distance problem is really the CM15A having a real poor RF reception range. My CM15A received none of my DS12As until I did an antenna mod on the CM15A.
If you continue to have problems. Search the forums for CM15A Antenna Modifications. There are many varied ways to do it.

[ratchet]

Knightrider and all,

Thanks for reading/responding!  It seems I was right with the distance problem.   I just added a short piece of wire to the antenna connection on the DS12A and now it is recognized by Active Home.  it seems to be reliable now.

 

What/where is the antenna connection?

[Brian H]

The antenna on a DS12A is part of the PC Boards etched runs.
It is not clear if the user actually soldered a wire to the board or taped a piece of wire near it on the case. Like some of us do with a passive antenna.

[ratchet]

The antenna on a DS12A is part of the PC Boards etched runs.
It is not clear if the user actually soldered a wire to the board or taped a piece of wire near it on the case. Like some of us do with a passive antenna.

In browsing around I did happen to find a thread mentioning where it was located and just tapping wire to any sensor.  Went quite a few days with my zone four, which is a usually open window, without a peep and then it started "Trouble Zone".  This is the zone I posted an image of that is in the same room as the console and that I moved the sensor from the right side of the window to the left.  It's been fine for several days then...?  We'll see how things go now.  Since they have a four hour block of time to "report" home these glitches can take a while to materialize.  If this works, I'll probably tape wire to all the sensors that are lying horizontal.