AMM32 two load micro module

[gavo]

Hello,

Whilst I appreciate this module may be for the European market I hope that the problem I have is fairly easy to solve.
I am trying to use this to automate my heating system, whereby load 1 switches on the household heating and load 2 switches on the hot water.
The manual states to hold down the programming button (on the module) until the led lights, then send an "all units off command" from the ActiveHome software, then send address for load 1 switching  (in this case A1) and then address for load 2 switching (in this case A2).

However on switching on A1 - load 1 and 2 switch on, switch off A1 - load 1 and 2 switch off

Switch on A2 - load 1 and 2 switch on, switch off A2 - load 1 and 2 switch off

There seems to be no way to assign A1 to load 1 and A2 to load 2.

Any ideas ?

Regards

Gavin