Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: AHP CM15A driver  (Read 3385 times)

bkenobi

  • PI Expert
  • Hero Member
  • ******
  • Helpful Post Rating: 24
  • Posts: 2089
AHP CM15A driver
« on: January 16, 2015, 11:38:20 PM »
I am using a different software for my HA system these days.  That being said, I have AHP installed on my file server and would like to run a test on it.  When I plugged the CM15A into it, the driver was set to a different one than AHP needs.  As a result, when I try to run AHP I get an error:
Code: [Select]
Error Getting X10Net Interface
I'm sure this is related to using the wrong USB driver.  Can someone point me to the correct location of the inf file that I need to use to switch over drivers?  I know it's on the system since I've switched back before, but I can't seem to remember where it was located.
Logged

bkenobi

  • PI Expert
  • Hero Member
  • ******
  • Helpful Post Rating: 24
  • Posts: 2089
Re: AHP CM15A driver
« Reply #1 on: January 17, 2015, 01:12:45 AM »
Never mind.  I forgot that I stopped the X10 service to allow the other driver to install.  After setting it back to "Automatic" and starting the service, AHP starts like a champ.  That's 3 hours I won't get back.   B:(
Logged

Tuicemen

  • Administrator
  • Hero Member
  • ****
  • Helpful Post Rating: 286
  • Posts: 10545
  • I don't work for X10, I use it successfuly!
Re: AHP CM15A driver
« Reply #2 on: January 17, 2015, 09:06:00 AM »
 rofl Been there!.............. ::) :'
Several times. :-[
Logged
Please Read Topic:
General Forum Etiquette
Before you post!

joe s.

  • Hero Member
  • *****
  • Helpful Post Rating: 4
  • Posts: 194
Re: AHP CM15A driver
« Reply #3 on: January 17, 2015, 10:03:34 AM »
Try to be philosophical - would you have cured the common cold in that same timeframe -:)?
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.