Please login or register.

Login with username, password and session length

Author Topic: Soft start dimmer won't remote dim after XPRESET command  (Read 1379 times)

PatPend

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 2
Soft start dimmer won't remote dim after XPRESET command
« on: February 18, 2016, 07:23:39 AM »

I have a few X10 soft start wall modules (X10 PRO XPS3/WS13A) controlled via a CM11A.  The modules are turned on using an xpreset command to a pre-set dim level.  If I later try to remote dim one of these modules up/down, it will not respond to the dim command.  If I manually turn the module on, remote dim works fine.  If I send a regular on command, then dim, dimming works, but then the preset on level is the last level the module was at, not the preset level.  Wondering if this is a bug or a feature and if anyone has ideas on workarounds.  Thanks, Russ
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: Soft start dimmer won't remote dim after XPRESET command
« Reply #1 on: February 18, 2016, 07:36:57 AM »

I am not sure if any of the information in the X10 wiki page may help you but you may find some information in it.
http://kbase.x10.com/wiki/Newer_Wall_Switches_and_Preset_Dim
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.