New/Replacement CM15A Only Works When Plugged Into the PC

Started by hpbenn, August 17, 2015, 10:08:17 PM

Previous topic - Next topic

hpbenn

The subject says it all. My old (11/2013) CM15A controller/interface died. Before death it worked like it was supposed to. I'd prepare an AHP program (strictly for lighting/no macros), download the program, unplug the USB cord from the CM15A, turn off the PC and walk away. I got a replacement CM15A controller last week and it works -- but only when plugged into the PC and the PC is on. Any thoughts other than/including the new unit is defective? (I downloaded a working program into the interface, and the "store in interface" box was checked for each action. Still, the controller -- which worked when USB-plugged into the PC -- did nothing once unplugged).

Noam

Did you try clearing the memory (there is a command in AHP to do this), and re-downloading?
Did you try fresh batteries?
Did you try resetting the unit (unplug it from the wall and the USB, remove the batteries, wait 10 minutes, put it all back together)?

SMF spam blocked by CleanTalk