Can not connect wifi Unit WM100

[astrothug]

  thanks Tuicemen, im sure i will get it going with the next one... lol...

[astrothug]

replacement unit  will be sent out... then mine sent back for repair. thanks all that suggested everything under the sun to try and thanks X10 for the quick response back.

[Tuicemen]

Authinx sent out a replacement this morning after giving it a test run.
A nice extra step on their end.

[astrothug]

Awesome news to here thanks for the update

[astrothug]

received second unit, I still can not connect to my 2.4 GHz WiFi router,  connection failed! I'm at a loss, I'm directly over my WiFi unit trying to set this up. will WPA2 personal security mode have issues with the x10 unit.

[HA Dave]

received second unit, I still can not connect to my 2.4 GHz WiFi router,  connection failed! I'm at a loss, I'm directly over my WiFi unit trying to set this up. will WPA2 personal security mode have issues with the x10 unit.

If you've lost your routers documentation you'll likely be able to find it on-line. There should be directions for allowing such device to use the router (my router has an little button to push). But even if no directions exist.... you can likely call the routers customer support/tech support. Could it be as simple as a password error?

[astrothug]

ok ok I used my iPad air 2 and it worked, but i cant turn on devices yet,  just trying a few things out.. will post update soon

[astrothug]

ok so i have an appliance module set to C3 and it works with my remote, but when i try with App i see the solid blue light turn yellow then back to blue on wifi unit,  but the Appliance module does not turn on... going to try a few more things...

[astrothug]

update was applied to my x10 wifi unit, said successful, still no luck with getting hub to turn on any of my x10 modules. 

[astrothug]

contacting x10 again yellow flashing when i send a signal from device to x10 until, maybe wait a few more years before kinks are worked out. 

[dave w]

contacting x10 again yellow flashing when i send a signal from device to x10 until, maybe wait a few more years before kinks are worked out. 

My does same action (if I understand what you are saying. "yellow flashing when i send a signal from device to x10 until, " you are sending command from phone or tablet to the WM100, correct?)  I think it is normal because everything is working normal. Did you try plugging WM100 and a target Appliance Module in same outlet strip and test, because it sounds like the WM100 PLC commands are not going anywhere.

[astrothug]

oh ya i have a video going up, no worries. will post not happy ....

[astrothug]

here is a video....  https://youtu.be/SOunbZbGmgs

[Tuicemen]

the module your using in the video looks to be a tm751 if that is correct it will not see PLC it only sees RF

[astrothug]

ok then why does the module not turn on with app but with remote and why does the wifi unit register that it has been turned on/off but can not send ....very frustrating..