Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[edjal]

 I am seeking info how to clear CM15 memory correctly for use with HG.  Here is what I have done with CM15 connected w PC via usb the batteries are removed. I checked Device mgr. to make sure I was connected via USB, Then in AHP I cleared history a couple of times, then cleared CM15 memory 8 times then in Hardware interface configuration I selected None for transceived house codes. I notice at this point there is an option button to Update interface. Should I select this option? To this point I have not I just went to file exit.  I do not have any other x10 controllers in use. I have been having a lot of erratic behavior with HG ever since changing to HG. For example at times when furnace X10 A2 scheduled on at 8am may also turn on Fam Rm light X10 A6 scheduled on 15 min after sunset.

[petera]

Yes you need to physically upload your new settings to the CM15 memory for your new settings to take effect. This will reflash the CM15 on board eeprom to blank status and you’re good to go.

[Tuicemen]

You need to purge macros too.
If you upload make sure your AHP has no devices setup in it.

[edjal]

  Thank You both for that information.  I hope that any other newbie converting from AHP to HG sees this post as I have spent countless hours trying to figure out what was causing these erratic issues. If only I had known the proper way to clear CM15.  Tuicemen I understand youre reccomending all macros and schedules be deleted not just disabled.  Correct?

[Tuicemen]

Correct