MyHouse Client Stuck in On/Off loop

Started by SaddleBear, June 06, 2006, 02:50:23 PM

Previous topic - Next topic

SaddleBear

Hello,

I can connect to the MyHouse service and it works fine for a while.  I can view the cameras in my house and change between them.  After a while when I switch camera's the MyHouse Status window shows the same command being issued OVER AND OVER.   Nothing works after this point.  I have to restart the web client machine and the machine at my house in order to get this to stop.  If I restart just the web client machine the commands are still being repeated.  I suspect its a problem with the AHP USB Module but I'm not sure.  I've attached a snapshot o fthe MyHouse status window showing the repeated commands (the Weiner Cam is the camera on my dachshunds ;-).

Any help would be appreciated.
Chris
saddlebear@hotmail.com


Tuicemen

Are you using another transciever? that will cause the repeat commands if not configured correctly in your AHP hardware configuration. Is it always the same cam that causes this?
Please Read Topic:
General Forum Etiquette
Before you post!

SaddleBear

I do have a transceiver in addition to the AHP module plugged in.  I forgot all about it.  I will remove it and see what happens.  Thanks for the reply!!!!!

Tuicemen

no problem I had forgoten about mine at one point too! ;)
Please Read Topic:
General Forum Etiquette
Before you post!