Odd Issue: From Remote Macros runs but doesn't work

[rayishome]

I have an RF remote that sends an G4 On Command.  This is reconized by the remote and blinks the macro, but the macro doesn't actually fire.  but, if you run the macro manually it works.   It's also odd with the Cam's.  In split screen mode the cam screen will update to show the correct cam tab but the signal to the cam is not making it.  howerver, once again if I run the macro that turns the cam on, it works fine. 

[philliec]

Interesting. I have had the same problem from time t time. I ended up re-writing the macro until it worked??? I hope that someone can post a solution to this.

[Tuicemen]

Check to make sure that In the AHP hardware configuration house code "G" is set as trancieved.