Topic: VCR Comander II Not getting siglal from Floodcams (Read 5204 times)

KVF · « **on:** August 23, 2006, 02:13:59 AM »

My floodcam security system was working OK. Would record video when motion was detected. Now VCR Commander II will only activate VCR when camera is turned on by hand held remote controller. VCR Commander II will not activate VCR when camera turns on with motion. Has anyone else had this problem? Would like some help! Thanks KVF.

Riverineb · « **Reply #1 on:** March 15, 2007, 03:52:28 PM »

Have you solved this problem,
I have 3 floodcams, I can get two to work fine motion and remote, but one will not work with the commander with motion, it will work with remote
any ideas
Gene

HA Dave · « **Reply #2 on:** March 15, 2007, 07:17:06 PM »

I just replied to that here

Riverineb · « **Reply #3 on:** August 13, 2007, 03:58:30 PM »

Quote from: Dave_x10_L on March 15, 2007, 07:17:06 PM

I just replied to that here

Dave, I cannot get any of the floodcams to activate with motion however, the VCR commander does beep when on home mode.
I can get the vcr commander to activate and I get a picture when I use the remote. Thats the only time it works ( with the remote). If the picture is on and working from using the remote and another camera trips all I get is a scrambled screen but the VCR commander with beep with the signal change.
Please help
Gene

News:

Author Topic: VCR Comander II Not getting siglal from Floodcams (Read 5204 times)

KVF

VCR Comander II Not getting siglal from Floodcams

Riverineb

Re: VCR Comander II Not getting siglal from Floodcams

HA Dave

Re: VCR Comander II Not getting siglal from Floodcams

Riverineb

Re: VCR Comander II Not getting siglal from Floodcams