Please login or register.

Login with username, password and session length

Author Topic: Removing or taking a module out of service on the DS7000  (Read 6415 times)

lynnymoore

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 7
Removing or taking a module out of service on the DS7000
« on: September 04, 2006, 03:17:49 PM »

I removed a Sensor from service but the DS7000 keeps showing the blinking red light where it used to be since it has not reported in within 4 hours. I read how to bypass a module that might not be functioning or is open (like  a window) but how do I clear the blinking red light on the DS7000 permanently?
http://Thank you!
Logged

TakeTheActive

  • Hero Member
  • *****
  • Helpful Post Rating: 126
  • Posts: 1047
  • Old !@#$% Tinkerer!
Re: Removing or taking a module out of service on the DS7000
« Reply #1 on: September 04, 2006, 05:00:33 PM »

I removed a Sensor from service but the DS7000 keeps showing the blinking red light where it used to be since it has not reported in within 4 hours...

...how do I clear the blinking red light on the DS7000 permanently?

The only way I know is:

  • Unplug the PS561 from the wall
    .
  • Disconnect the battery - Say some of your favorite choice words - Reconnect the battery
    .
  • Plug the PS561 into the wall - Re-enter all of your devices...  :-[
Logged
Low Post Count != Low Knowledge - High Post Count != High Knowledge ;)

ADVICE TO X-10 NEWBIES FROM AN X-10 OLD-TIMER
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.