Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Linking sending recieving units  (Read 20001 times)

Curby

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 1
Linking sending recieving units
« on: January 31, 2008, 02:03:47 AM »
Ok after much searching and trial and error I got all of my X10 software installed and running i have my sender and reciever 3 inches apart when i turn the sender off my tv goes static when i turn the unit on it says signal unusable and ideas?
Logged

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: Linking sending recieving units
« Reply #1 on: January 31, 2008, 04:51:52 PM »
Quote from: Curby on January 31, 2008, 02:03:47 AM
Ok after much searching and trial and error I got all of my X10 software installed and running

 i have my sender and reciever 3 inches apart when i turn the sender off my tv goes static when i turn the unit on it says signal unusable and ideas?

Do you plan to run the cameras via software/computer.... or on the TV or both?

I will have to assume... you have a working camera turned ON and connected to the sender unit.... and that the receiving unit is properly connected to the TV. First make sure your cables are OK... and that both the sender/receiver are set to the same channel. Try changing the channels (both on "B"... or both on "D").
Logged
Home Automation is an always changing technology
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.