Topic: Linking sending recieving units (Read 15362 times)

Curby · « **on:** January 31, 2008, 02:03:47 AM »

Ok after much searching and trial and error I got all of my X10 software installed and running i have my sender and reciever 3 inches apart when i turn the sender off my tv goes static when i turn the unit on it says signal unusable and ideas?

HA Dave · « **Reply #1 on:** January 31, 2008, 04:51:52 PM »

Quote from: Curby on January 31, 2008, 02:03:47 AM

Ok after much searching and trial and error I got all of my X10 software installed and running

i have my sender and reciever 3 inches apart when i turn the sender off my tv goes static when i turn the unit on it says signal unusable and ideas?

Do you plan to run the cameras via software/computer.... or on the TV or both?

I will have to assume... you have a working camera turned ON and connected to the sender unit.... and that the receiving unit is properly connected to the TV. First make sure your cables are OK... and that both the sender/receiver are set to the same channel. Try changing the channels (both on "B"... or both on "D").

News:

Author Topic: Linking sending recieving units (Read 15362 times)

Curby

Linking sending recieving units

HA Dave

Re: Linking sending recieving units