Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[kwilsonr]

PR511 Motion Sensor Floodlights just installed front and back and they won't turn off. There was an insert in the instructions describing what to do if they don't turn off and I followed these steps several times with no luck.

It's Sunday and support is closed. anyone have any advice on this one?

Thanks in advance. Ken

[Dan Lawrence]

What I did to control my PR511 was to use a Pro Wall Switch Appliance Module (XPS3) to control it.  The Wall Switch turns the PR511 on and off on a timer.  The PR511 is installed in AHP along with the Wall Switch in case I want the PR511 to say on for some reason (like Halloween).

[kwilsonr]

Thanks Dan. I searched the forums and found a suggestion to try turning it off with a remote and that worked. The lights are still acting flaky but I'm going to let them settle in overnight and see if I can get them dialed in tomorrow.

Great idea though. I may do that anyway.

[HA Dave]

.... It's Sunday and support is closed. anyone have any advice on this one?

Remember not to overload the light bulb wattage... 150 watts MAX (that's both bulbs).

When setting the light range... if set all the way to light... it will turn the lights ON when movement is detected. Even in daylight.

I really like the floodlights (PR511) they have proved to be a dependable and useful device at my home. I even use on now as part of my talking yard sign. I merely capped the wires that normally would have powered the floodlights.

[spam4us]

I mere capped the wires that normally would have powered the floodlights

I've used this approach as well.  I've also done the opposite of Dan by having the PR511 control a wall switch.  What I've done was to let the pr511 xmit to let's say B1.  I have a wall module that is set to B1 and controls the flood light.  The wall module I believe is rated up to 500 watts.  My flood is 300.  I set the pr511 to b16 and the +1 to xmit.  The PR511 wraps the code around to B1, xmits the B1 On over the powerline and turns on anything set to B1.  You can also set up a macro to trigger off of the B1 as well as having a mini controller set to house code B to control the flood independent of the Pr511.

[kwilsonr]

Just a followup to say the lights settled in nicely. A few adjustments for light/dark and range to get it where I wanted it. Everything works great and troublefree.

Is there a way to turn these off for a party without having to climb up and doing it manually? I have activehome pro if that makes a difference.

[eagle]

If you have it on a switch or a dedicated breaker, then just turn it off.

If not, then you may have to reach up and loosen the bulbs or cover up the sensor so they don't turn on and off during a party.

r,
eagle

[Brandt]

If a PR511 is turned on with an x10 ON signal, then they will stay ON until they receive their x10 OFF signal....They call this 'Barbecue mode'