Please login or register.

Login with username, password and session length

Author Topic: Wiring a KR10 as a leak detector transmitter.  (Read 5271 times)

BoyntonStu

  • Sr. Member
  • ****
  • Helpful Post Rating: 4
  • Posts: 112
Wiring a KR10 as a leak detector transmitter.
« on: January 18, 2011, 12:54:23 AM »

I would like to have an external switch in parallel with the ON/OFF push button.

When water is detected using my leak detector, the switch closes and the KR10 acts as if the button was pressed.

I wonder if anyone has wired a KR10 this way?
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: Wiring a KR10 as a leak detector transmitter.
« Reply #1 on: January 18, 2011, 09:29:45 AM »

The KR10A like the DS10A question in your other post. Is a Security Type Remote. I don't believe it will work with normal X10 devices.
I am not sure if the All Lights On and Off buttons. Send a true X10 On and Off to the address set on the console or if the console translates a command to standard X10 control.

The KR22A four button and KR19A two button. Key chain remotes do standard X10.
Logged

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: Wiring a KR10 as a leak detector transmitter.
« Reply #2 on: January 18, 2011, 01:35:08 PM »

There is a bunch of stuff written on using DS10A's for water detection. I've read a lot at the cocoontech.com Site. Some nice stuff here at this forum as well.

The cheap store bought siren units can normally be connected to a powerflash (regular X10) module as well.
Logged
Home Automation is an always changing technology
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.