Newbie Looking for help

Started by Slick, January 25, 2012, 04:48:22 PM

Previous topic - Next topic

Tuicemen

#15
Quote from: Slick on February 02, 2012, 09:40:42 PM

I still cannot get this to work. My security console in set to housecode A. I have lamp modules controlling security lights on A1, A2 and A3. I was planning to use A4 for my camera trigger. I have set the SW Security consol House code to A. The bottom section of the SW setup screen says it is not for signals from the security console. Where do I set my A4 for a Universal Module?
Sorry I missed this!  :-[
Your universal module can't be on house code A as that is the house code the console is sending Alllights On/ AllUnits Off signals
The module you wish to turn on must be a different house code and is the fist unit code of that house code
Use SpecifyX10Code to send RF on signal with alarm see attatched.( I used B1)
You Could however trigger a PCC Command to do most anything.
Please Read Topic:
General Forum Etiquette
Before you post!