I had the same prob - AH sent me a new
CM15A and so far so good. Also on my bad
unit flags didnt work at all, they work
fine on the new unit.
I did notice one thing so far if i setup a
macro with more than 1 delay in it,,, it
will not work properly. eg. set cam to
preset 1 delay 30 sec then preset 2 delay
30 sec then preset 1 (This will not always
work) sometimes it goes to the first preset
and thats it, doesnt run the rest of the
macro.
I have found a way around this - I made up
3 macros triggered by the same sensor, the
second and third macro have a delay start.
This meens that 3 macro trip at the same
time 1st puts camera in preset 1, second
macro has a 30 sec delay them puts cam in
preset 2 third has 1 min delay and puts cam
in preset 1 again - this works but put that
in the same macro amd its flaky at best..
Rob