Please login or register.

Login with username, password and session length

Author Topic: S/W crashes when editting program  (Read 2557 times)

gary

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
S/W crashes when editting program
« on: January 26, 2006, 11:17:33 AM »

A week ago I programmed my newly purchased
interface using  ActiveHome V3.199.
Everything seemed to go  well.  I
disconnected the interface from the
computer and plugged it into a centrally
located outlet and for a week the interface
controlled modules as expected.  I wanted
to  add some more commands to the interface,
so  I unplugged the module, brought it to
the  (XP) computer, removed the batteries
(because of a 'lock-up' problem with
interface not being recognised), and
plugged  it into the outlet and the USB
cable.  The  unit was identified.  I fired
up the  ActiveHome S/W and tried to edit a
module's  programing.  The S/W crashed.  I
restarted  the S/W and tried to delete and
add  programming to a module.  Crash again!
I'm hoping this is beginner's poor luck, but
I'm  beginning to think this was the worst
$100  I've ever spent.  Since I removed the
batteries, I've lost the  programming in the
interface and because the  program crashes,
I can't reprogram the  interface.    PS:
I've used Powerhouse on a Macintosh OS6-8
for over 20 years and never had these  types
of problems.
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.