Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[robandcathy]

I have the macro function, with the eagle eye sensor on D1 I set that to my trigger and the first line is to turn on B2 Front door light wait 5min and then off, I look in my activity monitor and see that D1 is received but I never see the B2 ON signal sent, does anyone why? from my remote B2 works fine also the sensor has fresh batt. so I'm sure the signal is good

[JMac]

Try a one second delay in the macro before B1 activation.  This worrked for me in a similar situation

[JMac]

I meant before the B2 ON activation

[jawaid]

Do you see a 'B2 ON' being sent if you manually activate the B2 module from the AHP GUI?

[-Bill- (of wgjohns.com)]

Make sure House Code "D" is set as a "Tranceived House Code" in AHP Hardware Setup.

[robandcathy]

will the house code tras.. set to d affect the timers on the a code ; this is my setup A and B are all my switches c  is cameras and D is sensors what would be the best way to set up my usb transciver, i have timers to trigger lights for me in the morining on the a code

[-Bill- (of wgjohns.com)]

will the house code tras.. set to d affect the timers on the a code ; this is my setup A and B are all my switches c  is cameras and D is sensors what would be the best way to set up my usb transciver, i have timers to trigger lights for me in the morining on the a code

From my experience with AHP, I would suggest setting all of the houscodes to transceived unless this causes problems.  I think the macros will not be triggered if the house code of their trigger isn't set to be transceived.