Contact | X10.com
Please login or register.

Login with username, password and session length

Author Topic: Eagle Eye and Aluminum Siding  (Read 2651 times)

redidbull

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
Eagle Eye and Aluminum Siding
« on: November 17, 2009, 11:19:25 AM »
Does any one know if aluminum siding will prevent an eagle eye from working? I have one on my house and the LEDs work as you pass by but the chime inside does not work. Removing it from the house, I have it velcroed so can just pull it off with out removing the batteries and it seems to work. Thanks for any help. Jim
Logged

dave w

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 139
  • Posts: 6116
Re: Eagle Eye and Aluminum Siding
« Reply #1 on: November 17, 2009, 11:33:54 AM »
Yes. The metal blocks the radio signal, especially when the metal is between the motion sensor and the tranceiver. You might get it to work by getting the motion sensor off the metal by an inch or so.
Logged
"This aftershave makes me look fat"

HA Dave

  • Hero Member
  • *****
  • Helpful Post Rating: 175
  • Posts: 7127
Re: Eagle Eye and Aluminum Siding
« Reply #2 on: November 17, 2009, 12:41:51 PM »
I've also found that a window can make good portals for RF as well. For motion sensors or cameras, if you can get ether or both, the sender and/or receiver, near a window it should help.
Logged
Home Automation is an always changing technology

redidbull

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 6
Re: Eagle Eye and Aluminum Siding
« Reply #3 on: November 17, 2009, 01:32:40 PM »
Thank you both. It is right near a window so I will move it to the trim casing. It is only about 8" from where it is now. Thanks. Jim
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.