Please login or register.

Login with username, password and session length

Author Topic: x10 Console Set Up  (Read 4801 times)

TonyAncheta

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
x10 Console Set Up
« on: April 15, 2012, 02:03:45 AM »

I can't find in the manual how to assign a particular zone as an "entry," so that the delay will work correctly.

Would someone explain how to do this?

Thanks,

Tony A-
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: x10 Console Set Up
« Reply #1 on: April 15, 2012, 08:52:30 AM »

Which security console?
If it is the SC1200 you can pick the zone where a sensor is registered.
Page 14 of the users manual gives the method. Basically you pick the zone by the number and then install it. The default is the next open zone as you add them.
Logged

TonyAncheta

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: x10 Console Set Up
« Reply #2 on: April 15, 2012, 09:46:01 AM »

Which security console?
If it is the SC1200 you can pick the zone where a sensor is registered.
Page 14 of the users manual gives the method. Basically you pick the zone by the number and then install it. The default is the next open zone as you add them.


Hello Brian,

It is the SC1200.

I got that far, but how do I assign 'zone 1' as the zone to be 'entry delayed?'  I can find no sub menu under either the 'Entry Delay' or 'Zone set' details of the manual or the unit?

TIA

Tony A 
Logged

Brian H

  • Community Organizer
  • Hero Member
  • ***
  • Helpful Post Rating: 305
  • Posts: 13259
Re: x10 Console Set Up
« Reply #3 on: April 15, 2012, 11:00:23 AM »

You can not set any Zones to delayed or not delayed on the console.

The switch setting in each sensor determines if it can send a delayed trigger and on how the console was armed.
If the switch in the sensor is set to MAX it can be used for an entry and exit delay.
If set to MIN it always triggers an alarm immediately.

The entry and exit delays are only enabled with the Console Armed Away button. Where the Entry and Exit Delays timers are used.
Armed Home does not enable the delays for sensors set to MAX.

Arming from the Keyfob also does not enable any Entry or Exit delays.

The SH624 remote in some kits can also enable delays Entry and Exit for sensors set to MAX.
Even Armed Home where normally no delays are enabled. If you get the switches correct.

« Last Edit: April 15, 2012, 11:12:51 AM by Brian H »
Logged

TonyAncheta

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 3
Re: x10 Console Set Up
« Reply #4 on: April 16, 2012, 01:48:10 AM »

Thank you, Brian, that answers the question.

Tony A-
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.