PLC01 Repeater - problems, solutions?

Started by smatofu, June 24, 2021, 04:26:52 PM

Previous topic - Next topic

brobin

It's really a matter of 'raise the bridge (signal) or lower the river (noise)' so I think you'll find that the installation of one of Jeff's XTB-IIR devices at your panel will solve your problems against all but the most serious offenders.  Without one I would have given up on X10 many years ago.  Installing one breathed new life into X10 for me.  Compared to other X10 devices it's pricey but I've saved the cost many times over in time and frustration.  Jeff doesn't have many many left so buy one while you still can.  You WILL be amazed.

smatofu

#16
Quote from: brobin on June 30, 2021, 04:26:58 PM
...buy one while you still can.  You WILL be amazed.

Yes, I know. I have to replenish my home automation budget and convince my wife that we need another device.


smatofu

#17
Reporting back to the community:

After a lot of tweaking, the PLC01 works well!

I have it connected through an appliance module. I turn the PLC01 on at the beginning of macros (or after dimming sequences), and  I turn it off at the end. This is done to overcome PLC01 incompatibility with CM15A.

I also have a repeating schedule to turn the PLC01 off from my WM100 in case PLC01/CM15A floods the grid with "infinite chatting loop". An alternative solution would be to buy a short-time timer that would power cycle PLC01 every few minutes. This is needed because when PLC01/CM15A start chatting there is no stopping it other than unplugging PLC01 from power.

As you can see there is a lot of tweaking, but the macros are working flawlessly now with macros signal reaching every room (including rooms behind GFCI).

(Ultimately I will invest in XTB-IIR)

S.

brobin

Quote from: smatofu on July 09, 2021, 08:33:43 AM

(Ultimately I will invest in XTB-IIR)


Better do it soon, Jeff only has a handful left before they're gone for good.

JeffVolp

Quote from: brobin on July 09, 2021, 10:06:49 AM
Quote from: smatofu on July 09, 2021, 08:33:43 AM

(Ultimately I will invest in XTB-IIR)


Better do it soon, Jeff only has a handful left before they're gone for good.

14 new plus 1 refurb out of a total of 1660 as of 7/11.

Jeff
X-10 automation since the BSR days

SMF spam blocked by CleanTalk